Til toppen

Ekinex EK-BF1-TP-DP1, KNX / DALI Gateway 1 channel

Produktnummer: 13364850
Lagerbeholdning:

inkl. mva.

Ekinex® Gateways EK-BF1-TP-D1 used to control electronic control gear (ECG) with a DALI interface (according to EN 62386) via the KNX installation bus.

Description

Ekinex® Gateways EK-BF1-TP-D1/D2 are devices used to control electronic control gear (ECG) with a DALI interface (according to EN 62386) via the KNX installation bus. The device converts switching and dimming commands from the connected KNX system into DALI telegrams and status information from the DALI bus into KNX telegrams.

Connections
  • KNX port with standard connector
  • Screw terminals for DALI bus
Technical Data
  • Device power supply: 110-240 Vac or DC
  • KNX bus power supply
Supply

The scope of delivery includes a terminal for connection to the KNX bus line and a 1.2 x 2 cm heat shrink tubing for additional insulation of the bus cable.

Other information

DALI® (Digital Addressable Lighting Interface) is a worldwide standard for interfacing lighting control solutions whose data transmission protocol is contained in IEC 62386. DALI is a registered trademark of ZVEI (Zentralverband Elektrotechnik- und Elektronikindustrie e.V.).

With firmware version 0.2.5 or higher, the device is certified according to EN 62386-101 and -103 ed2 (DALI2) and therefore authorised to carry the DALI-2 logo.

Functions / Features

Besides the pure gateway function, the EK-BF1-TP-D1/D2 also offers numerous additional functions:

  • EK-BF1-TP-D1: addressing of up to 16 DALI groups or 63 individual ECGs
  • EK-BF1-TP-D2: addressing of up to 2x16 DALI groups or 2x63 individual electronic ballasts
  • Flexible DALI commissioning concept with ETS5
  • Light colour control using type 8 ECG devices
  • Light colour control according to different ECG subtypes
  • Hourly programming for group and ECG control by value and/or colour
  • Different operating modes such as permanent mode, night mode or staircase mode
  • Integrated operating hours counter for each group and ECG with alarm when maximum duration is reached
  • Individual fault recognition with objects for each lamp / ECG
  • Complex failure analysis at group/device level with calculation of the number of failures and failure rate
  • Fault threshold monitoring with individually configurable threshold values
  • Scene module for extensive scene programming and dimming possibilities
  • Quick replacement' function for easy replacement of individual defective ECGs
  • Manual control of group and broadcast telegrams via control buttons on the device
  • Fault status signalling via LED on the device

Configurationa and commissioning

  • ETS application v.5 and 6 for configuring the KNX functions of the device
  • DCA App as special interface for configuring DALI segments